Hull model (May 1988)

The model is scaled 1/2 inch to the foot and was shaped from glued up blocks of scrap RenShape 450 (a model making material that is used in the auto industry). We were fortunate that Columbia provided approximate hull lines in their sales brochure. The most difficult part was to get the paint lines straight and fine to within about 1/2 mm (0.02 inches).

The completed model, mounted on a display board, is show below.

This view shows the model and display board, as mounted in the boat on the port side of the forward bulkhead.

(Revised: 25 Jan 2018)

Helmsman Seat (May 1988)

Designed and built an arched helmsman seat that fits and mounts between the cockpit seats, at the rear of the cockpit. It allows the helmsman sit in a forward facing position. It also provides some support, when the boat is heeled, for a person sitting diagonally in the aft corner(s) of the cockpit.

The seat is secured to the inner walls of the cockpit with two barrel bolts. These allow the seat to be removed and stowed in the starboard lazarette when not in use.

{Lesson learned:

Do not put up with being uncomfortable if you find a way to cure it.}

Cushion Fabric (May 1988)

Sewed new upholstery fabric covers for all interior cushions. New on left, old, typical, on right.